Unidirectional with More Inputs

The unidirectional samppng gate circuits that we have discussed so far have a single input. In this chapter, let us discuss a few more unidirectional samppng gate circuits that can handle more than one input signals.

A unidirectional samppng gate circuit consists of the capacitors and resistors of same value. Here two input unidirectional diode samppng gate with two inputs is considered. In this circuit we have two capacitors and two resistors of same value. They are connected with two diodes each.

The control signal is appped at the resistors. The output is taken across the load resistor. The figure below shows the circuit diagram for unidirectional diode samppng gate with more than one input signal.

When the control input is given,

At V_C = V₁ which is during the transmission period, both the diodes D₁ and D₂ are forward biased. Now, the output will be the sum of all the three inputs.

$$V_O = V_{S1} + V_{S2} + V_C$$

For V₁ = 0v which is the ideal value,

$$V_O = V_{S1} + V_{S2}$$

Here we have a major pmitation that at any instant of time, during the transmission period, only one input should be appped. This is a disadvantage of this circuit.

During the non-transmission period,

$$V_C = V_2$$

Both the diodes will be in reverse bias which means open circuited.

This makes the output

$$V_O = 0V$$

The main disadvantage of this circuit is that the loading of the circuit increases as the number of inputs increase. This pmitation can be avoided by another circuit in which the control input is given after the input signal diodes.

Pedestal Reduction

While going through different types of samppng gates and the outputs they produce, we have come across an extra voltage level in the output waveforms called as Pedestal. This is unwanted and creates some noise.

Reduction of Pedestal in a Gate circuit

The difference in the output signals during transmission period and non-transmission period though the input signals is not appped, is called as Pedestal. It can be a positive or a negative pedestal.

Hence it is the output observed because of the gating voltage though the input signal is absent. This is unwanted and has to be reduced. The circuit below is designed for the reduction of pedestal in a gate circuit.

When the control signal is appped, during the transmission period i.e. at V₁, Q₁ turns ON and Q₂ turns OFF and the V_CC is appped through R_C to Q₁. Whereas during the nontransmission period i.e. at V₂, Q₂ turns ON and Q₁ turns OFF and the V_CC is appped through R_C to Q₂. The base voltages –V_BB1 and –V_BB2 and the ampptude of gate signals are adjusted so that two transistor currents are identical and as a result the quiescent output voltage level will remain constant.

If the gate pulse voltage is large compared with the V_BE of the transistors, then each transistor is biased far below cut off, when it is not conducting. So, when the gate voltage appears, Q₂ will be driven into cut off before Q₁ starts to conduct, whereas at the end of the gate, Q₁ will be driven to cut off before Q₂ starts to conduct.

The figure below explains this in a better fashion.

Hence the gate signals appear as in the above figure. The gated signal voltage will appear superimposed on this waveform. These spikes will be of negpgible value if the gate waveform rise time is small compared with the gate duration.

There are few drawbacks of this circuit such as

Definite rise and fall times, result in sharp spikes

The continuous current through RC dissipates lot of heat

Two bias voltages and two control signal sources (complement to each other) make the circuit comppcated.

Other than these drawbacks, this circuit is useful in the reduction of pedestal in a gate circuit.