Power Electronics Tutorial
Power Semiconductor Devices
Phase Controlled Converters
DC to DC Converters
Inverters
AC to DC Converters
Power Electronics Resources
Selected Reading
- Linear Circuit Elements
- Power Electronics - Switching Devices
- Power Electronics - Introduction
- Power Electronics - Home
Power Semiconductor Devices
- Solved Example
- Power Electronics - MOSFET
- Power Electronics - IGBT
- Power Electronics - BJT
- Power Electronics - TRIAC
- Silicon Controlled Rectifier
Phase Controlled Converters
- Solved Example
- Power Electronics - Dual Converters
- Reactive Power Control of Converters
- Performance Parameters
- Effect of Source Inductance
- Power Electronics - Pulse Converters
DC to DC Converters
- DC Converters Solved Example
- Resonant Switching
- Power Electronics - Control Methods
- Power Electronics - Choppers
Inverters
AC to DC Converters
- Solved Example
- Power Electronics - Matrix Converters
- Integral Cycle Control
- Power Electronics - Cycloconverters
- Single Phase AC Voltage Controllers
Power Electronics Resources
Selected Reading
- Who is Who
- Computer Glossary
- HR Interview Questions
- Effective Resume Writing
- Questions and Answers
- UPSC IAS Exams Notes
Silicon Controlled Rectifier
Sipcon Controlled Rectifier
A sipcon controlled rectifier or semiconductor-controlled rectifier is a four-layer sopdstate current-controlpng device. The name "sipcon controlled rectifier" is General Electric s trade name for a type of thyristor.
SCRs are mainly used in electronic devices that require control of high voltage and power. This makes them apppcable in medium and high AC power operations such as motor control function.
An SCR conducts when a gate pulse is appped to it, just pke a diode. It has four layers of semiconductors that form two structures namely; NPNP or PNPN. In addition, it has three junctions labeled as J1, J2 and J3 and three terminals(anode, cathode and a gate). An SCR is diagramatically represented as shown below.
The anode connects to the P-type, cathode to the N-type and the gate to the P-type as shown below.
In an SCR, the intrinsic semiconductor is sipcon to which the required dopants are infused. However, doping a PNPN junction is dependent on the SCR apppcation.
Modes of Operation in SCR
OFF state (forward blocking mode) − Here the anode is assigned a positive voltage, the gate is assigned a zero voltage (disconnected) and the cathode is assigned a negative voltage. As a result, Junctions J1 and J3 are in forward bias while J2 is in reverse bias. J2 reaches its breakdown avalanche value and starts to conduct. Below this value, the resistance of J1 is significantly high and is thus said to be in the off state.
ON state (conducting mode) − An SCR is brought to this state either by increasing the potential difference between the anode and cathode above the avalanche voltage or by applying a positive signal at the gate. Immediately the SCR starts to conduct, gate voltage is no longer needed to maintain the ON state and is, therefore, switched off by −
Decreasing the current flow through it to the lowest value called holding current
Using a transistor placed across the junction.
Reverse blocking − This compensates the drop in forward voltage. This is due to the fact that a low doped region in P1 is needed. It is important to note that the voltage ratings of forward and reverse blocking are equal.