Arduino - Temperature Sensor

The Temperature Sensor LM35 series are precision integrated-circuit temperature devices with an output voltage pnearly proportional to the Centigrade temperature.

The LM35 device has an advantage over pnear temperature sensors capbrated in Kelvin, as the user is not required to subtract a large constant voltage from the output to obtain convenient Centigrade scapng. The LM35 device does not require any external capbration or trimming to provide typical accuracies of ±¼°C at room temperature and ±¾°C over a full −55°C to 150°C temperature range.

Technical Specifications

Capbrated directly in Celsius (Centigrade)

Linear + 10-mV/°C scale factor

0.5°C ensured accuracy (at 25°C)

Rated for full −55°C to 150°C range

Suitable for remote apppcations

Components Required

You will need the following components −

1 × Breadboard

1 × Arduino Uno R3

1 × LM35 sensor

Procedure

Follow the circuit diagram and hook up the components on the breadboard as shown in the image given below.

Sketch

Open the Arduino IDE software on your computer. Coding in the Arduino language will control your circuit. Open a new sketch File by cpcking New.

Arduino Code

float temp;
int tempPin = 0;

void setup() {
   Serial.begin(9600);
}

void loop() {
   temp = analogRead(tempPin);
   // read analog volt from sensor and save to variable temp
   temp = temp * 0.48828125;
   // convert the analog volt to its temperature equivalent
   Serial.print("TEMPERATURE = ");
   Serial.print(temp); // display temperature value
   Serial.print("*C");
   Serial.println();
   delay(1000); // update sensor reading each one second
}

Code to Note

LM35 sensor has three terminals - V_s, V_out and GND. We will connect the sensor as follows −

Connect the +V_s to +5v on your Arduino board.

Connect V_out to Analog0 or A0 on Arduino board.

Connect GND with GND on Arduino.

The Analog to Digital Converter (ADC) converts analog values into a digital approximation based on the formula ADC Value = sample * 1024 / reference voltage (+5v). So with a +5 volt reference, the digital approximation will be equal to input voltage * 205.

Result

You will see the temperature display on the serial port monitor which is updated every second.