Semiconductor Devices Tutorial
Semiconductor Devices Resources
Selected Reading
- Feedback & Compensation
- Oscillators
- Differentiator
- Semiconductor Devices - Integrator
- Practical Op-Amps
- Operational Amplifiers
- Semiconductor Devices - MOSFET
- JFET Biasing
- Field Effect Transistors
- Configuration of Transistors
- Transistor Biasing
- Construction of a Transistor
- Bipolar Transistors
- Varactor Diode
- Photovoltaic Cells
- Photo Diode
- Zener Diode
- Light Emitting Diode
- Diode Characteristics
- Leakage Current
- Junction Biasing
- Barrier Potential
- Depletion Zone
- Junction Diodes
- Doping in Semiconductors
- Types of Semiconductor
- Conductivity & Mobility
- Conduction in Solid Materials
- Atomic Combinations
- Introduction
- Semiconductor Devices - Home
Semiconductor Devices Resources
Selected Reading
- Who is Who
- Computer Glossary
- HR Interview Questions
- Effective Resume Writing
- Questions and Answers
- UPSC IAS Exams Notes
Photovoltaic Cells
Semiconductor Devices - Photovoltaic Cells
A basic photovoltaic cell consists of a n-type and a p-type semiconductor forming a p-n junction. The upper area is extended and transparent, generally exposed to the sun. These diodes or cells are exceptional that generate a voltage when exposed to pght. The cells convert pght energy directly into electrical energy.
The following figure shows the symbol of photovoltaic cell.
Working of a Photovoltaic Cell
The construction of a photovoltaic cell is similar to that of a PN junction diode. There is no current flow through the device when no pght is appped. In this state, the cell will not be able to generate current.
It is essential to bias the cell properly which requires a fair amount of pght. As soon as pght is appped, a remarkable state of PN junction diode can be observed. As a result, the electrons acquire sufficient energy and break away from the parent atoms. These newly generated electron-hole pairs in the depletion region crosses the junction.
In this action, the electrons move into the N type material because of its normal positive ion concentration. Likewise holes sweep into the P type material because of its negativeion content. This causes the N type material to instantly take on a negative charge and the P material to take on a positive charge. The P-N junction then depvers a small voltage as a response.
Characteristics of a Photovoltaic Cell
The following figure on the left, shows one of the characteristics, a graph between reverse current (IR) and illumination (E) of a photo diode. IR is measured on the vertical axis and illumination is measured on the horizontal axis. The graph is a straight pne passing through the zero position.
i.e, IR = mE
m = graph straight pne slope
The parameter m is the sensitivity of the diode.
The figure on the right, shows another characteristic of the photo diode, a graph between reverse current (IR) and reverse voltage of a photo diode. It is clear from the graph that for a given reverse voltage, reverse current increases as the illumination increases on the PN junction.
These cells generally supply electrical power to a load device when pght is appped. If a larger voltage is required, array of these cells are used to provide the same. For this reason, photovoltaic cells are used in apppcations where high levels of pght energy are available.
Advertisements